1/4" Diameter Solid Carbide Spiral Flush Trim Router Bits, 2-Flute, 1/4" Shank
Top quality, American-made, solid carbide router bits direct from the factory. These 1/4" diameter Solid Carbide Spiral Flush Trim Bits use a special twin-bearing pilot to follow a pattern or trim material flush with mating surfaces. The small diameter gets into tight inside corners in intricate patterns. The super sharp spiral flutes cut surprisingly fast and leave a surface that needs minimal sanding. They’re also a great choice for hand-held trimming with smaller routers. We make them in 3 cutting lengths, 1", 1-1/4" and 1-1/2".
You no longer have to settle for inferior quality imported bits to save money. Woodpeckers uses state-of-the-art CNC grinding equipment, the highest quality solid carbide blanks and ultra-fine grinding wheels to produce American-made router bits at extremely competitive prices. The days of paying extra for middle-man markups are over. Buy direct from the manufacturer and pocket the savings.
American Made Quality – Factory Direct Pricing
Up-Cut or Down-Cut? Up-Cut bits pull the chips up and out of the cut more effectively. They’re a great choice for solid wood. Down-Cut bits slice down into the material so surface fibers don’t get lifted. This is particularly important on cabinet grade plywood. A Down-Cut bit will give you a super clean edge in even the thinnest surface veneers.
Like all Woodpeckers products, Ultra-Shear Solid Carbide Flush Trim Bits are made right here in our Strongsville, Ohio, facility just south of Cleveland.
*NOTE: The Buy 2 or More Savings is offered when 2 or more of the same Bits are purchased.
|Country of Manufacture||United States|
WARNING: Wood Dust created by Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection.